David Show

HDFC HDFC HDFC HDFC 3 Column Layout Column 1 Content for the first column. Column 2 Content for the second column. Column 3 Content for the third column.

DIY Wooden Desk Lamp First of all make triangle base of dimension 150mm x 90mm x 19mm board. Then take two wooden pieces of dimension 430mm x 50mm and 300mm x 50mm. Take smaller piece (300mm x 50mm) and cut the end at 70 degree both side but opposite to each other. Now take larger piece (430mm x 50mm) and make grove into it for led placement. Take smaller piece (300mm x 50mm) and make a grove behind it and insert pipe for wiring to pass through and then seal it with wood filling. Place led strip in to grove and cover it with acrylic sheet, pass wire through the pipe (inserted in samller wood) and then to the base. Attach the top wood to the smaller wooden piece and together attach them to wooden base piece. Fill all the voids with woodfilling and then sand it with fine sand paper for better result. Then apply some paint on it and you are ready to go... Finshed Product... Watch & Subscribe

DIY Gaming Desk  I was felling uncomfortable with my old table so, I started to make it my self. This table is 4 foot by 2 foot on the top shelves and has 5 inches overhang on all over four side. This is the overview of the under shelves skeleton. It's dimension are 38 inch, 32 inch, 16 inch, 16 inch as shown in the figure above. This is the table legs which are 31 inch long as shown in the figure above. This the table leg part whose dimensions are 3 inch up from the bottom and 5 inch down from the upper edge of table leg. This is the lower edge table space around the table for  cable management  which is 5 inch lower from the table top.   This is the table top whose dimensions are  48 inch x 24 inch

    The 74xx595 devices contain an 8-bit, serial-in parallel-out (SIPO). The storage register has parallel 3-state outputs. Separate clocks are provided for both the shift and storage register. The shift register has a direct overriding clear (SRCLR) input, serial (SER) input and serial outputs for cascading. When the output-enable (OE) input is high, the output are in high impedance state. Pin Configuration Circuit Diagram This Switch Diagram Configuration is for Data, Out-Enable, Latch, Clock Pins as shown above in picture This is whole working circuit for shift register but there is a slight change in the Clear Pin, in this push button is grounded Vcc - 5Volts R1 - 1k ohms C - 47microfard R2 - 1k ohms R3 - 10k ohms QH' - This is for the next shift register to make 16 bit ouput led and so on. (This pin 9 goes to the DATA PIN of next shift register) Watch video for more details...

First of all go to Inventables   https://www.inventables.com/  and then sign in to your account and launch Easel. Download this image below and go to "Import" and then to "Image Trace" When the image trace is complete, click on the "Invert" option and then click on import. Resize to your dimensions and depth to 2mm. Select material MDF or you can choose your and bit size to 1/8 inch (straight cut) and Simulate Crave it .....! After the curving, sand the edge little bit with sandpaper. Color the engrave letter with your favourite color.  This is all for Marvel fan I hope you might like it.