David Show

Decoration Lamp Take a wooden ply piece of dimension 190mm x 120mm x 19mm and cover it with laminates. Take another 3 piece of  dimension (270mm x 100mm x 19mm) x 2 and 290mm x 60 mm x 5mm plyboard. Take 5mm thickness plyboard and sandwich it between 19mm thickness board. Keep some space around it as the 5mm plyboard is small in width. Now, Take the sandwich piece and laminate it on both side. Take smaller piece (190mm x 120mm ) and drill three holes - Two for screw and One for Wire to pass through. Joint the upper part with lower part. For cleaness apply paint to corner for better look. The grove left is for led strip (12 volts). Pass the wire through the hole we left, and cover 3/4 side with led strip. Finished Product.  Watch & Subscribe

DIY Wooden Desk Lamp First of all make triangle base of dimension 150mm x 90mm x 19mm board. Then take two wooden pieces of dimension 430mm x 50mm and 300mm x 50mm. Take smaller piece (300mm x 50mm) and cut the end at 70 degree both side but opposite to each other. Now take larger piece (430mm x 50mm) and make grove into it for led placement. Take smaller piece (300mm x 50mm) and make a grove behind it and insert pipe for wiring to pass through and then seal it with wood filling. Place led strip in to grove and cover it with acrylic sheet, pass wire through the pipe (inserted in samller wood) and then to the base. Attach the top wood to the smaller wooden piece and together attach them to wooden base piece. Fill all the voids with woodfilling and then sand it with fine sand paper for better result. Then apply some paint on it and you are ready to go... Finshed Product... Watch & Subscribe